Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Happs Super Joystick height issues  (Read 1164 times)

0 Members and 1 Guest are viewing this topic.

wescotte

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 58
  • Last login:September 15, 2004, 01:16:15 am
  • I'm a llama! I didn't want to change it
Happs Super Joystick height issues
« on: December 24, 2002, 02:37:41 am »
I'm currently using 5/8" wood for my CP. I'd also like to cover the CP with a sheet of Lexan. However the joystick doesn't seem to have a long enough handle. Even if I route out the 5/8" more than half way the joystick is still only about 3" high. Adding the sheet of lexan I fear will make it even worse. I am using the longer of the two spacers that the joystick came with. Am I doing something wrong? Suggestions?

Eric
Logged
Pages: [1]
  
Go Up
« previous next »