| Main > Main Forum |
| New Product: Versa49 (TM) Balltop Replacement Shafts for HAPP 49-Ways |
| << < (9/12) > >> |
| markrvp:
I've been extremely busy with work this summer and just now got around to installing my 49-way balltop shaft. The shaft being a little longer than the stock stick makes installing fl0yd's rotary adapter be a bit off. Basically the extra length of the shaft causes it not to be down tight against the grommet. You can pull the shaft up and down a little kind of like in a milk churn. Since fl0yd's adapter eliminates use of the E-clip underneath, this problem could be fixed with a longer plastic sleeve that goes between the shaft and the rotary switch. Has anyone else used their Versaball shafts with fl0yd's adapter? If so, what was your workaround for the play in the shaft? |
| Kremmit:
The hardware store has nylon washers & spacers in lots of sizes. I bet you could find some that would take up the slack. |
| fl0yd:
I have already started a conversation with the plastics company that did the coupler for the original shaft. |
| fl0yd:
Bump I would like replies from RandyT and the general public. |
| Timoe:
I'm sure that I'll need at least 2 eventually. |
| Navigation |
| Message Index |
| Next page |
| Previous page |