Main > Main Forum

New Product: Versa49 (TM) Balltop Replacement Shafts for HAPP 49-Ways

Pages: << < (7/12) > >>

Minwah:


--- Quote from: Toonces on July 26, 2005, 02:01:48 am ---Any chance you could take a picture of the bottom? I am kind of space constrained in my Namco Cyberlead cabinet and had to adjust the stock bat handles for minimal bottom protrusion.

--- End quote ---

I can take a pic when I get home...

If you look at Randy's pic in the first post, the only part of the shaft which is visible at the bottom is the section under the lowest e-clip groove (<1cm).  If that helps at all...

SirPoonga:


--- Quote from: Popcorrin on July 18, 2005, 07:19:04 pm ---Can these be lit with an led?  I'm guessing no but thought I would ask to be sure.

--- End quote ---
Looking closely at the pics, the shafts are not hollow.

Popcorrin:


--- Quote from: SirPoonga on July 26, 2005, 10:02:49 am ---
--- Quote from: Popcorrin on July 18, 2005, 07:19:04 pm ---Can these be lit with an led?
--- End quote ---

--- End quote ---


SirPoonga:

Well, look at the side by side pic with the bat-top.  The shaft comes to a point, therefore I doubt it is hollow.

Toonces:


--- Quote from: Minwah on July 26, 2005, 04:46:43 am ---
--- Quote from: Toonces on July 26, 2005, 02:01:48 am ---Any chance you could take a picture of the bottom? I am kind of space constrained in my Namco Cyberlead cabinet and had to adjust the stock bat handles for minimal bottom protrusion.

--- End quote ---

I can take a pic when I get home...

If you look at Randy's pic in the first post, the only part of the shaft which is visible at the bottom is the section under the lowest e-clip groove (<1cm).  If that helps at all...

--- End quote ---

Thanks Minwah! That helps a lot. I think they'll work for me.

Toonces

Pages: << < (7/12) > >>

Go to full version