| Main > Main Forum |
| New Product: Versa49 (TM) Balltop Replacement Shafts for HAPP 49-Ways |
| << < (7/12) > >> |
| Minwah:
--- Quote from: Toonces on July 26, 2005, 02:01:48 am ---Any chance you could take a picture of the bottom? I am kind of space constrained in my Namco Cyberlead cabinet and had to adjust the stock bat handles for minimal bottom protrusion. --- End quote --- I can take a pic when I get home... If you look at Randy's pic in the first post, the only part of the shaft which is visible at the bottom is the section under the lowest e-clip groove (<1cm). If that helps at all... |
| SirPoonga:
--- Quote from: Popcorrin on July 18, 2005, 07:19:04 pm ---Can these be lit with an led? I'm guessing no but thought I would ask to be sure. --- End quote --- Looking closely at the pics, the shafts are not hollow. |
| Popcorrin:
--- Quote from: SirPoonga on July 26, 2005, 10:02:49 am --- --- Quote from: Popcorrin on July 18, 2005, 07:19:04 pm ---Can these be lit with an led? --- End quote --- --- End quote --- |
| SirPoonga:
Well, look at the side by side pic with the bat-top. The shaft comes to a point, therefore I doubt it is hollow. |
| Toonces:
--- Quote from: Minwah on July 26, 2005, 04:46:43 am --- --- Quote from: Toonces on July 26, 2005, 02:01:48 am ---Any chance you could take a picture of the bottom? I am kind of space constrained in my Namco Cyberlead cabinet and had to adjust the stock bat handles for minimal bottom protrusion. --- End quote --- I can take a pic when I get home... If you look at Randy's pic in the first post, the only part of the shaft which is visible at the bottom is the section under the lowest e-clip groove (<1cm). If that helps at all... --- End quote --- Thanks Minwah! That helps a lot. I think they'll work for me. Toonces |
| Navigation |
| Message Index |
| Next page |
| Previous page |