| Main > Main Forum |
| fl0yds Rotary Adapter plug question |
| (1/1) |
| Timoe:
http://www.markoates.com/rotary/TechSupport.htm I am a bit confused. I finished my soldering on the switch, now I need to connect my wires to the plug. When I look on Mark Oates' website instructions i see the first table with the following info Table 1 13-pin Connector Rotary Switch Pin 1 Pin 1 Pin 2 Pin 2 Pin 3 Pin 3 and so on until .... Pin 12 Pin 12 Pin 13 Pin A Then a little farther down I see this table 13-pin Connector Rotary Switch Druin's PCB Pin 1 Pin A Pin 1 Pin 2 Pin 1 Pin 2 Pin 13 Pin 12 Pin 13 So does the cable from pin "A" on the switch go to pin (1) on the connector or (13) ??? Also is there a "top" or "bottom" on these connectors (they're not in front of me now). Does it matter what side the pin one goes into? Thank you |
| fl0yd:
That's a good catch. I'd updated the one table, but failed to update the other. Pin A on the switch goes to pin 13 on the connector, and pin 13 on druin's. (I'll double check this when I get home.) |
| Timoe:
A*W*E*S*O*M*E* |
| fl0yd:
Pin A on the switch needs to connect to Pin 13 on Druin's and on the 13 pin connector. I've updated the site. Thank you for pointing that out. :) Mark |
| Navigation |
| Message Index |