Main > Main Forum

Best way to laminate sides of control panel

Pages: << < (3/5) > >>

Knievel:

Good eye, it's only worth buying when on sale. You might want to check with Ponyboy(over in the b&s forum)and see if he can grab it for you. Don't know if he can get any further discount but he could probably save you some shipping $.

nickbuol:


--- Quote from: Knievel on July 14, 2005, 02:32:35 pm ---Good eye, it's only worth buying when on sale. You might want to check with Ponyboy(over in the b&s forum)and see if he can grab it for you. Don't know if he can get any further discount but he could probably save you some shipping $.

--- End quote ---

His price was $5 a foot.

nickbuol:

See my note a couple of posts up.  Happ said that the discount price was for a full 150 foot roll only.  I guess I should have zoomed in closer on the .PDF as I would have seen that is was a 'l/150' (meaining lot/150' roll) and not a '1/150' (meaning 1' increments/150' roll)....

$5 a foot is a bit high ($55 for 7" by 10.5', with a LOT left over) for my tastes....

Maybe I will check out the Parts Express stuff.

dema:


--- Quote from: nickbuol on July 14, 2005, 04:18:20 pm ---See my note a couple of posts up.
--- End quote ---


nickbuol:

Yup.

Pages: << < (3/5) > >>

Go to full version