| Main > Main Forum |
| Best way to laminate sides of control panel |
| << < (3/5) > >> |
| Knievel:
Good eye, it's only worth buying when on sale. You might want to check with Ponyboy(over in the b&s forum)and see if he can grab it for you. Don't know if he can get any further discount but he could probably save you some shipping $. |
| nickbuol:
--- Quote from: Knievel on July 14, 2005, 02:32:35 pm ---Good eye, it's only worth buying when on sale. You might want to check with Ponyboy(over in the b&s forum)and see if he can grab it for you. Don't know if he can get any further discount but he could probably save you some shipping $. --- End quote --- His price was $5 a foot. |
| nickbuol:
See my note a couple of posts up. Happ said that the discount price was for a full 150 foot roll only. I guess I should have zoomed in closer on the .PDF as I would have seen that is was a 'l/150' (meaining lot/150' roll) and not a '1/150' (meaning 1' increments/150' roll).... $5 a foot is a bit high ($55 for 7" by 10.5', with a LOT left over) for my tastes.... Maybe I will check out the Parts Express stuff. |
| dema:
--- Quote from: nickbuol on July 14, 2005, 04:18:20 pm ---See my note a couple of posts up. --- End quote --- |
| nickbuol:
Yup. |
| Navigation |
| Message Index |
| Next page |
| Previous page |