Main > Main Forum
Transparent Control Panel
<< < (3/3)
Jollyrob:
it shouldn't be too hard, cause after a little bit of replanning iv'e decided best way to do it is to make it almost like any other panel, have lexan as a top layer, difference will be a rectangular hole in the middle of the CP top, so think of it as any other panel with a lexan top but with a big fat hole in the middle of the top wood, so cutting wouldnt' be any different than any other panel, the only thing that may still be a pain is the cleaning like you mentioned, but i'm only mounting the buttons and sticks in lexan, so i only have to clean around that, the encoder,wires, and such will mostly be following the bottom of the CP box and be pretty much out of the way, plus i think my method would actually seal it pretty well anyway.
Navigation
Message Index
Previous page

Go to full version