Main > Main Forum

V2 Spinner rattle...

Pages: << < (2/2)

Elfman:


--- Quote from: Hoagie_one on July 05, 2005, 10:29:21 am ---had me worried.
--- End quote ---


Elfman:


--- Quote from: Gamecab on July 04, 2005, 11:28:30 pm ---Solution - Go to the hardware store and pick up a small bottle of 3 in 1 oil. (It has to be 3 in 1 and not WD40 because the 3 in 1 will clean out any bits of sawdust that may be trapped in the nylon bearing). Remove your Spinner knob and put 3 drops between the blue nylon bearing and the steel shaft, do the same for the bottom bearing. Now give it a spin and I bet its as good as new again.

--- End quote ---

Just in case anyone else has had this problem, Charlies solution fixed my rattling immediately.  The 3 in 1 oil worked great!

Thanks again!

Scoobie:

Would sewing machine oil work as well?

johnk:

Thanks very much!!!  This fixed the vibration on two of my spinners.

I used "Needle-Tip Precision Oiler" from Radio Shack ($3), part # 64-2301A.  It says it will last almost indefinitely.

Pages: << < (2/2)

Go to full version