| Main > Main Forum |
| V2 Spinner rattle... |
| << < (2/2) |
| Elfman:
--- Quote from: Hoagie_one on July 05, 2005, 10:29:21 am ---had me worried. --- End quote --- |
| Elfman:
--- Quote from: Gamecab on July 04, 2005, 11:28:30 pm ---Solution - Go to the hardware store and pick up a small bottle of 3 in 1 oil. (It has to be 3 in 1 and not WD40 because the 3 in 1 will clean out any bits of sawdust that may be trapped in the nylon bearing). Remove your Spinner knob and put 3 drops between the blue nylon bearing and the steel shaft, do the same for the bottom bearing. Now give it a spin and I bet its as good as new again. --- End quote --- Just in case anyone else has had this problem, Charlies solution fixed my rattling immediately. The 3 in 1 oil worked great! Thanks again! |
| Scoobie:
Would sewing machine oil work as well? |
| johnk:
Thanks very much!!! This fixed the vibration on two of my spinners. I used "Needle-Tip Precision Oiler" from Radio Shack ($3), part # 64-2301A. It says it will last almost indefinitely. |
| Navigation |
| Message Index |
| Previous page |