Main > Main Forum

MDF paint process?

Pages: << < (3/3)

armax:


--- Quote from: tkuper05 on June 29, 2005, 05:48:18 pm ---I'm very ignorant with types of paint.
--- End quote ---


tkuper05:

I've been reading some about using a sealer to make the end pieces look consistent to the flat, broad pieces due to the fact that the end pieces soak up a ton of primer/paint.  Anyone else do this?  I think I'm gonna go with latex primer/latex paint.  I don't care how long it takes to dry.

SteveJ34:


--- Quote from: tkuper05 on June 29, 2005, 06:55:22 pm ---I've been reading some about using a sealer to make the end pieces look consistent to the flat, broad pieces due to the fact that the end pieces soak up a ton of primer/paint.  Anyone else do this?  I think I'm gonna go with latex primer/latex paint.  I don't care how long it takes to dry.

--- End quote ---

All the edges I ended up with were covered with t-molding. This was the two sides and the edges of the CP.


Pages: << < (3/3)

Go to full version