| Main > Main Forum |
| MDF paint process? |
| << < (3/3) |
| armax:
--- Quote from: tkuper05 on June 29, 2005, 05:48:18 pm ---I'm very ignorant with types of paint. --- End quote --- |
| tkuper05:
I've been reading some about using a sealer to make the end pieces look consistent to the flat, broad pieces due to the fact that the end pieces soak up a ton of primer/paint. Anyone else do this? I think I'm gonna go with latex primer/latex paint. I don't care how long it takes to dry. |
| SteveJ34:
--- Quote from: tkuper05 on June 29, 2005, 06:55:22 pm ---I've been reading some about using a sealer to make the end pieces look consistent to the flat, broad pieces due to the fact that the end pieces soak up a ton of primer/paint. Anyone else do this? I think I'm gonna go with latex primer/latex paint. I don't care how long it takes to dry. --- End quote --- All the edges I ended up with were covered with t-molding. This was the two sides and the edges of the CP. |
| Navigation |
| Message Index |
| Previous page |