Main > Main Forum
wow i got it to work THANKYOU!
(1/8) > >>
paradox:
I bought an old mashed cab of ebay for
AlanS17:
What game is it? If you're in test mode you probably just need to find and flip the test switch. If you don't have one then you will probably have to wire one up.
eggedd2k:
yeh the board is in test mode.  don't change the dip switch settings unless you're sure what each one does - write down the current switch settings for reference.  once you know what game it is you should be able to get the switch settings off the net and get it running. post the details on here someone will know what game it is
paradox:
thankyou for your reply!

the game is taito football champ

where do i wire the test button to?

i know that it next to video ground in the jamma pinout but who does it press a button if it only one pin?

or would you ground it and where too

please respond
AlanS17:
You would wire up a button with one end going into the "test" pin and another going into one of the "ground" pins (there are several and any should work fine).

If that doesn't work, you'll likely have to go egg's route and see if there isn't some test mode built into the board. I don't know enough about that particular game to tell you. You'll find that in the manual, though. If you don't have one, you can probably find one online in PDF format.
Navigation
Message Index
Next page

Go to full version