Main > Main Forum
I-PAC VE Grounding issue
(1/1)
sc1103:
I finally decided to wire up all 7 of my CP buttons to my I-PAC VE (i formerly just had 4 and the joystick). When I have the daisy-chain ground completed, buttons 5,6, and 1A (button 7) do not register, but Start 1, which uses the same ground, does, and if I swap the controls for button 2 and 7, button 2 then registers as button 7 so the connection is good...anyone have any ideas whats wrong  ???
Tiger-Heli:
Sounds like it has to be a wiring problem, but . . .
CJK:
Did you check continuity of your ground wiring? (I.e., one probe on the first connector in the chain, one probe on the last.) I agree with T-H -- seems like it has to be a wiring issue.

-- Chris
sc1103:

--- Quote from: CJK on June 22, 2005, 08:09:31 am ---Did you check continuity of your ground wiring? (I.e., one probe on the first connector in the chain, one probe on the last.) I agree with T-H -- seems like it has to be a wiring issue.

-- Chris

--- End quote ---

It could be a wiring issue, it just seems strange as the lst button on the chain, the P1 Start has power.  Im going to try rewiring, it may just be my error. 
Navigation
Message Index

Go to full version