| Main > Main Forum |
| Powering an electronic coin mech... |
| (1/1) |
| eggedd2k:
got a question about electronic coin mechs. I've got one in my cab and i'm trying to figure out how it's powered. i've not traced the wires yet but i will do. i know it needs 12v - and I believe it gets this via the psu in the back of the cabinet. can anyone verify this? |
| wpcmame:
--- Quote from: eggedd2k on June 21, 2005, 04:38:05 am ---got a question about electronic coin mechs. --- End quote --- |
| eggedd2k:
is the power for the coin mech likely to connect to the jamma connector at all? |
| Ken Layton:
Electronic coin mechs are made in many voltage requirements. Here are the typical ones: 5 volt dc 6 volt dc 12 volt dc 15 volt dc 24 volt dc 12 volt ac 24 volt ac 48 volt ac 120 volt ac Suggest contacting your mech's manufacturer (armed with the exact model number and other numbers from it's nameplate) tech support department. If you have a Mars Electronics unit then visit www.meiglobal.com |
| eggedd2k:
it's a 12v coin controls one |
| Navigation |
| Message Index |