| Main > Main Forum |
| can i use dremmel for tmolding? |
| (1/7) > >> |
| alundra:
router is a little expensive to me..i can find all those good dremmel at flea market and pawnshop for a very cheap price..so yea..im thinking use the dremmel instead..i only install the tmolding on the top board of the CP..any comment? thanks |
| AlanS17:
You're welcome to give it a shot, but I wouldn't expect it to work properly. In fact, I tried once before and I wasn't happy with the result. |
| nobody:
i think you can, it just takes alot of time |
| Veinman:
You could do it, but you will need a very steady hand. Unless of course you have the dremel "drill press" table or whatever it is. |
| dmsuchy:
I would buy a cheap router, like Roybi or Craftsman. It take quite a motor to cut all the t molding slots, thats alot of material to cut through. Also a router is a great tool for almost anything. |
| Navigation |
| Message Index |
| Next page |