Main > Main Forum

Topfire Ball/Battops...

Pages: << < (18/18)

richms:


--- Quote from: markrvp on August 03, 2005, 09:00:36 pm ---Looks like a good solution.  All you need is a mono 1/8" jack.  Then you can get a 1/8" cable with plug and cut off the end you don't need.  Then just run those to your encoder (1 wire is ground, the other goes to the correct input).

--- End quote ---

They are obviously using the 4 position 2.5mm sockets like nokias have for headsets, I guess if you used the same plug you could have both 2 colours of illumination and the button or multiple buttons if you were to put a flightstick type control on (ooooooh hatswitch ;)

slayj:

Any new news guys..............?????

AllisterFiend:

BUMP!!!


Anyone still looking into this?

I know this is an old thread but I see all these new products coming out but no one seems to be tackling this one.  Am I the only one out there who thinks there needs to be a better topfire joystick than the one that happs sells.  It's awful looking and does not even fit in with my control panel.

It would be nice to see RandyT incorporate a topfire into his GPWiz49 joystick.


Hint, Hint ;D, You have 4 sold already if you decide to market one.

Allister Fiend

Pages: << < (18/18)

Go to full version