| Main > Main Forum |
| Question for people using TVs in their MAME cab. |
| << < (4/4) |
| DrewKaree:
Not having done it myself, I'm only guessing here, but I'd think the case bezel of the TV would get in the way of a decent fit/finish of the Happ bezel. Why go over an existing bezel when you can remove it and get a better fit? |
| Trenchbroom:
--- Quote from: paigeoliver on June 02, 2005, 02:04:23 am --- If you just decase it then the heat problem goes away. --- End quote --- Actually, in my case I don't have a back to the cabinet (was water damaged and broke into two pieces when I picked the cab up from the disposal area of the local distributor). And with little ones in the house who could get access to the back I figured it would be best just to leave it as is for now. But for Pacman decasing might work. --- Quote from: DrewKaree on June 03, 2005, 11:36:39 pm ---Not having done it myself, I'm only guessing here, but I'd think the case bezel of the TV would get in the way of a decent fit/finish of the Happ bezel. Why go over an existing bezel when you can remove it and get a better fit? --- End quote --- Well the nice thing about the Midway cabs is that they are setup for the sliding plexiglass bezel with the artwork on the sides. The TV already has a bit of a "bezel" from the case anyway, and with the artwork bezel in place it looks pretty professional. Especially since you are looking at a square screen that is wider than the vertical monitor that was intended for that space. Of course, since I don't have a back door to the cab I wasn't going for the "arcade authentic" look anyway... ;D maybe someday. |
| Navigation |
| Message Index |
| Previous page |