| Main > Main Forum |
| Carbon fiber cutting |
| << < (2/2) |
| AlanS17:
Unless it's prone to cracking, I'd say get that saw moving as fast as you can and just cut through it as quickly as possible. A slow saw is what will cause splintering. |
| rdagger:
--- Quote from: AlanS17 on May 31, 2005, 06:28:56 pm ---Unless it's prone to cracking, I'd say get that saw moving as fast as you can and just cut through it as quickly as possible. A slow saw is what will cause splintering. --- End quote --- It's recommended not to use a fast saw because it means more dust. --- Quote ---Isn't WD-40 flammable? --- End quote --- |
| danny_galaga:
cut same way you would fibreglass. wear a dust mask. i dont think you need coolant for it but if you do dont get electrocuted! |
| Navigation |
| Message Index |
| Previous page |