| Main > Main Forum |
| T-molding? |
| (1/1) |
| Q*Bert_OP:
Wher can I get GOOD QUALITY(3'32) bits(dremmel or router) for making a groove for t-molding? Thanks. |
| AlanS17:
I don't recommend a Dremel for cutting the groove. It's not sturdy enough from my experience. |
| Teknique:
http://www.carbide.com/ plug in "slot cut" in the search- everything you need here.... Tek |
| AlanS17:
Check this thread for router bits... http://forum.arcadecontrols.com/index.php/topic,37176.0.html |
| Q*Bert_OP:
Thanks for all the help. I've finally found th right router bit. |
| Navigation |
| Message Index |