Main > Main Forum

LED-Wiz USB LED and Output Control Device now available. *Blinky lights*

Pages: << < (87/92) > >>

SirPoonga:


--- Quote from: JoyMonkey on February 08, 2006, 07:59:15 am ---There's also an event based system that I haven't had the time to try out, at the moment it's only set up for Q*Bert (to make the knocker knock when Q*Bert dies).


--- End quote ---
The commandline version has this too, I hope :)
I think I found a power supply and relay for my knocker :)

mahuti:

SirPoonga... share man, share. I'd like to get that setup too... and I don't wanna start stripping my pinball machine.

MikeQ:

It should be going up on the site tonight.  I wanted to wait until I had some ads up so I can pay for this little endeavor.  I guess I'll just skip the ads for now though.  I also need to merge up with the 0.104 release.  That only takes about 15 minutes to do.  My son has t-ball tonight so It may be late tonight but I'll try to get the Open Beta posted.

MYX:

Good Goin eh'  ;D

SirPoonga:


--- Quote from: mahuti on February 08, 2006, 11:58:33 am ---SirPoonga... share man, share. I'd like to get that setup too... and I don't wanna start stripping my pinball machine.

--- End quote ---
Radioshack
273-1668
Resister that down to 27V.

Now, as for the relay I am not sure
275-233
The description says 12VDC but the contents says 5VDC.  So the question is what voltage switches it? 
Eidt: 275-232
The other must have a typo.  I beleive 275-232 is the relay needed.

Pages: << < (87/92) > >>

Go to full version