| Main > Main Forum |
| LED-Wiz USB LED and Output Control Device now available. *Blinky lights* |
| << < (87/92) > >> |
| SirPoonga:
--- Quote from: JoyMonkey on February 08, 2006, 07:59:15 am ---There's also an event based system that I haven't had the time to try out, at the moment it's only set up for Q*Bert (to make the knocker knock when Q*Bert dies). --- End quote --- The commandline version has this too, I hope :) I think I found a power supply and relay for my knocker :) |
| mahuti:
SirPoonga... share man, share. I'd like to get that setup too... and I don't wanna start stripping my pinball machine. |
| MikeQ:
It should be going up on the site tonight. I wanted to wait until I had some ads up so I can pay for this little endeavor. I guess I'll just skip the ads for now though. I also need to merge up with the 0.104 release. That only takes about 15 minutes to do. My son has t-ball tonight so It may be late tonight but I'll try to get the Open Beta posted. |
| MYX:
Good Goin eh' ;D |
| SirPoonga:
--- Quote from: mahuti on February 08, 2006, 11:58:33 am ---SirPoonga... share man, share. I'd like to get that setup too... and I don't wanna start stripping my pinball machine. --- End quote --- Radioshack 273-1668 Resister that down to 27V. Now, as for the relay I am not sure 275-233 The description says 12VDC but the contents says 5VDC. So the question is what voltage switches it? Eidt: 275-232 The other must have a typo. I beleive 275-232 is the relay needed. |
| Navigation |
| Message Index |
| Next page |
| Previous page |