Main > Main Forum
Stainless steel dust covers *Other custom work too*
markrvp:
I would definitely be in for a pair.
crashwg:
Ooh ooh ooh, me too! ;D
Franco:
Ill look forward to seeing the marquee knievel.
If anyone would like a pair, post or PM me the following info and I will see what I can do.
DIMENSIONS:
D1 - Outside Diameter
D2 - Bore Diameter
D3 - Width
EDGE PROFILE:
A - Flat with chamferd corners to remove sharp edge
B - Full radius and chamfer.
C-
Kremmit:
Franco-
Figured if we're taking measurements, we oughtta post 'em, so you don't get 50 people all measuring the same joystick.
Here are the measurements for a Wico leafswitch joystick dustwasher. These are almost certainly good for a Happ Perfect 360 joystick as well, but since I don't have one of those, I wont' say that's for sure.
d1 - outside diameter: 2 inches / 51 mm
d2 - bore diameter: 7/16 inch / 11 mm update: This measurement was VERY snug. I'd go with at least 15/32 or 11.5 mm next time.
d3 - thickness: 1/16 inch / 1.5 mm
Original Wico dustwashers have a dead flat edge profile, but I like B: Full Radius and chamfer.
You've got PM!
Franco:
I have just finished making four of the above washers to Kremmits Wico dimensions. Ill post some pics of them tonight.