| Main > Main Forum |
| Stainless steel dust covers *Other custom work too* |
| << < (2/8) > >> |
| markrvp:
I would definitely be in for a pair. |
| crashwg:
Ooh ooh ooh, me too! ;D |
| Franco:
Ill look forward to seeing the marquee knievel. If anyone would like a pair, post or PM me the following info and I will see what I can do. DIMENSIONS: D1 - Outside Diameter D2 - Bore Diameter D3 - Width EDGE PROFILE: A - Flat with chamferd corners to remove sharp edge B - Full radius and chamfer. C- |
| Kremmit:
Franco- Figured if we're taking measurements, we oughtta post 'em, so you don't get 50 people all measuring the same joystick. Here are the measurements for a Wico leafswitch joystick dustwasher. These are almost certainly good for a Happ Perfect 360 joystick as well, but since I don't have one of those, I wont' say that's for sure. d1 - outside diameter: 2 inches / 51 mm d2 - bore diameter: 7/16 inch / 11 mm update: This measurement was VERY snug. I'd go with at least 15/32 or 11.5 mm next time. d3 - thickness: 1/16 inch / 1.5 mm Original Wico dustwashers have a dead flat edge profile, but I like B: Full Radius and chamfer. You've got PM! |
| Franco:
I have just finished making four of the above washers to Kremmits Wico dimensions. Ill post some pics of them tonight. |
| Navigation |
| Message Index |
| Next page |
| Previous page |