Main > Main Forum
Translucent Microswitch Buttons*Taking Pre-Orders*
NY_in_TX:
(sniff) you had me at translucent...you had me at translucent :'(
YOU HAVE BEEN PAID!!!! I've been standing by the front door for minutes now! WHERE ARE MY BUTTONS!!! :P
just kiddin shawnzilla.... thanks again!!!
ny
shawnzilla:
--- Quote from: NY_in_TX on June 25, 2005, 11:14:38 pm ---(sniff) you had me at translucent...you had me at translucent :'(
YOU HAVE BEEN PAID!!!! I've been standing by the front door for minutes now! WHERE ARE MY BUTTONS!!! :P
just kiddin shawnzilla.... thanks again!!!
ny
--- End quote ---
I'm gonna have to fire that delivery driver! ;)
Heffaklumpen:
I'm not sure it's just me who is stupid or if it has just not been mentioned here yet, but how do you guys fasten the LED's under the buttons?
Do you just use some glue or what? ???
shawnzilla:
--- Quote from: Heffaklumpen on June 26, 2005, 09:01:16 am ---I'm not sure it's just me who is stupid or if it has just not been mentioned here yet, but how do you guys fasten the LED's under the buttons?
Do you just use some glue or what? ???
--- End quote ---
Here is the way I do it:
1) Remove plunger & spring
2) Place the LED in the bottom of the bezel, with one lead going out of each hole. (I usually pre-wire the led for the sake of being easy)
3) Replace spring & plunger
No need for glue, drilling, etc...
Knievel:
I show the drill method HERE if you want to go that route, use a 3/16" bit.
KUDOS on getting this done Shawn and for keeping that price down, AMAZING job.
Look forward to ordering lots of these in the future.