Main > Main Forum
Router question?
<< < (7/7)
Steve Kaz:
My $60 Craftsman worked great (as i said earlier in the thread) and it has a 2HP motor.  I was impressed with it, but i haven't used many other routers.  It uses 1/4 shank bits
DrewKaree:
1/2" shank bits

larger selection of bits
more material being put into the cut
generally less effort to cut with

And as pointed out, less likely to be able to bend the bit.
nostrebor:
Avoid the harbor freight routers. They have a reputation for not holding their height adjustments, and the collets are know for not holding bits well. Basically, nothing will stay where you put it.
Kev-in DFW:
Also, make sure you avoid the Router/Table combo from Ryobi at Home Depot.  I had that setup and on about the third use, the collar came completely apart which made it impossible to adjust depth settings. 

A couple of months ago I picked up a DeWalt combo at Sears with a fixed and plunge base.  It was on clearance for $99.00.  I see them on eBay regulary for about $150.00.  I absolutely love it and it it has both the 1/4" and 1/2" collets.

Good Luck,

Kev~
Navigation
Message Index
Previous page

Go to full version