Main > Main Forum

Fiberoptics as t-molding??

Pages: << < (2/4) > >>

Veinman:

WOW that is one hideous "website."

IMO, that much light might get distracting, but it sure would look cool.

cholin:


--- Quote from: Veinman on May 09, 2005, 10:14:29 pm ---WOW that is one hideous "website."
--- End quote ---

Couldnt agree more!  Sounds like an opertunity for me!  But anyway, Id go for some glow wire or something.

pointdablame:

wow. that's pretty pricy stuff.   And couple that with the fact that they want you to use a 150 watt metal halide bulb.... your cabinet is going to get HOT FAST!!!

EL wire is much cheaper, easier to use/cut/apply, uses a LOT less power, and creates almost no heat.

Personally, I still don't see any reason to use this other than the "hey I used fiber optics" factor.  It's a good idea, but there are much better alternatives.

JDSkydiver:

I agree...

I'd think using a "neon-esque" flourescent list just under the lip of the CP might give a nice "ground effect" look.

But IMO, the Fiber optics might be a bit much...

But what do I know...?

JDSkydiver

shmokes:

I can't help dropping this website every time someone points out a bad website.  This is the place where I ordered my T-molding.  It was over a year ago and the website is still the same.  Really awful.  Your eyes will bleed.

Sorry for the hijack...kind of.

Pages: << < (2/4) > >>

Go to full version