Main > Main Forum
Fiberoptics as t-molding??
<< < (2/4) > >>
Veinman:
WOW that is one hideous "website."

IMO, that much light might get distracting, but it sure would look cool.
cholin:

--- Quote from: Veinman on May 09, 2005, 10:14:29 pm ---WOW that is one hideous "website."
--- End quote ---

Couldnt agree more!  Sounds like an opertunity for me!  But anyway, Id go for some glow wire or something.
pointdablame:
wow. that's pretty pricy stuff.   And couple that with the fact that they want you to use a 150 watt metal halide bulb.... your cabinet is going to get HOT FAST!!!

EL wire is much cheaper, easier to use/cut/apply, uses a LOT less power, and creates almost no heat.

Personally, I still don't see any reason to use this other than the "hey I used fiber optics" factor.  It's a good idea, but there are much better alternatives.
JDSkydiver:
I agree...

I'd think using a "neon-esque" flourescent list just under the lip of the CP might give a nice "ground effect" look.

But IMO, the Fiber optics might be a bit much...

But what do I know...?

JDSkydiver
shmokes:
I can't help dropping this website every time someone points out a bad website.  This is the place where I ordered my T-molding.  It was over a year ago and the website is still the same.  Really awful.  Your eyes will bleed.

Sorry for the hijack...kind of.
Navigation
Message Index
Next page
Previous page

Go to full version