Main > Main Forum
Joystick Grommet (Real Identity)
<< < (8/9) > >>
whammoed:

--- Quote from: brandon on May 18, 2005, 02:44:03 pm ---this might not work but... What if you take a drill bit that's the size you want to go to and turn the tip down on a lathe to match the smaller size.
--- End quote ---
Avery:

--- Quote from: RandyT on May 17, 2005, 04:04:05 pm ---Thanks for the suggestion, but we need to go through steel encapsulated in the rubber, not just the rubber part.

--- End quote ---

I see where my misunderstanding came from now.  Oooops.  <Looks Sheepish>

So, as you actually have some of these in your hand, is it possible you could push the insert out (say using a block with a hole in it to let the insert pass through, but support the rubber) and then put your own insert in there?

Also, I just looked and Lord has a distributor about 5 miles from where I work (give me convienence or give me death).  If I want to run out and get a couple of these things, how much should I expect to be paying?
brandon:

--- Quote from: whammoed on May 18, 2005, 03:12:58 pm ---
--- Quote from: brandon on May 18, 2005, 02:44:03 pm ---this might not work but... What if you take a drill bit that's the size you want to go to and turn the tip down on a lathe to match the smaller size.
--- End quote ---

--- End quote ---
Kremmit:

--- Quote from: PoDunkMoFo on May 18, 2005, 01:42:24 pm ---I don't know if they should have given me that info so let's just say the company was somewhere between nearway and farway.

--- End quote ---

I wasn't aware they were even still making their own sticks.  I thought all their designs that were still in production had been licensed out to Happ?
PoDunkMoFo:

--- Quote from: Avery on May 18, 2005, 03:33:17 pm ---is it possible you could push the insert out (say using a block with a hole in it to let the insert pass through, but support the rubber) and then put your own insert in there?

--- End quote ---

The metal insert is molded into the rubber removing it would ruin the part.

See the picture in the e-bay link above.
Navigation
Message Index
Next page
Previous page

Go to full version