| Main > Main Forum |
| My Tee Nuts don't hold well. :( |
| << < (3/11) > >> |
| Franco:
Drill a pilot hole 0.5 - 1.00 mm or so smaller than the O/D of the t-nut shaft, countersink it slightly and hammer them in for an interference fit. I used this method and mine have taken some severe punishment n havent even shown a sign of moving. --- Quote from: Tiger-Heli on April 29, 2005, 12:40:44 pm ---Heh, I did the same thing, ONCE!!! The flat part of the T-nut is supposed to go on TOP of the panel so the screw tension pulls them down and holds the joystick tight. See how OSCAR did it: http://www.oscarcontrols.com/sinistar/index.shtml --- End quote --- BTW, mine are mounted from the underside of the CP and Ive had no problems but them again they are pass through nuts. I got mine from B&Q in the UK so I cant help you out stockist wise. |
| markrvp:
--- Quote from: Flinkly on April 29, 2005, 01:10:11 pm ---the thread about the happs 49way template shows the bottom of a blitz arcade control panel (straight from the factory) and has the t-nuts done in from the bottom, like yours forces you to. --- End quote --- |
| Franco:
--- Quote --- --- End quote --- |
| Flinkly:
ah...i guess i didn't understand the picture. i guess i should have noticed from the placement of the dust washer. |
| markrvp:
--- Quote from: Franco on April 29, 2005, 02:43:57 pm --- --- Quote --- --- End quote --- --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |