Main > Main Forum
HAPP 49-WAY Mounting Template **NOW FOR REALLY THICK PANELS**
<< < (4/11) > >>
IntruderAlert:
I did a quick measurement on the Blitz99 CP this morning
The holes in the plexi are 1 1/2"
markrvp:
Thank you Intruder Alert.  Randy gave me a quick panic attack. 

I drilled 1-1/2" holes last night in a new panel.
dema:
Not to panic you once again markrvp, but how are you going to wire the 2p 49 way joystick with the 1p buttons right next to the optic board? Don't you need more clearance on the left side of the joystick to get everything hooked up?
IntruderAlert:
I plan to remove one of the Blitz joysticks tonight
It looks like the dust washer is below the CPO
but I only gave it a quick look
markrvp:

--- Quote from: dema on April 28, 2005, 09:55:09 am ---Not to panic you once again markrvp, but how are you going to wire the 2p 49 way joystick with the 1p buttons right next to the optic board? Don't you need more clearance on the left side of the joystick to get everything hooked up?

--- End quote ---

No, there is plenty of room.  The dark grey bar on the mounting template is the actual clearance needed with a FloppyCable connector attached to the optic board (oriented to the left).  The optic board does not stick out on the right side any farther than the joystick base.
Navigation
Message Index
Next page
Previous page

Go to full version