Main > Main Forum

Hagstrom KE72 Error

Pages: << < (2/6) > >>

CPickler:

I tried the suggestions.

I can boot just fine as long as neither of the IDE cables are plugged in.  I am going to start searching for anything I plugged in incorrectly.

LPZ:

If you running windows 2000 make sure you load your configuration file thru the serial port.

CPickler:

I'm running XP.

I haven't actually been able to load up a configuration yet.

I went through and checked all the connections.  All of them were on NO a couple of them the female quick disconnect was not seated properly and that has been fixed.  But I still get the problem with any of the IDE cables attached.

Do I need to just boot up with just the card abd keyboard and serial cable connected to load a configuration before connecting the IDE cables?

CPickler:

if some of the buttons are not grounded properly could that cause the problem?

I have all of them connected to ground, but I think that a few of the connections may be loose or something.  Actually there is a possibility that any of the connections could of course be bad, I haven't gotten to test any of it yet.

LPZ:

Just a thought here: check the keyboard passthru port to make sure you have your input and output correct.  If their wrong, nothing will work.

Pages: << < (2/6) > >>

Go to full version