| Main > Main Forum |
| Hagstrom KE72 Error |
| << < (2/6) > >> |
| CPickler:
I tried the suggestions. I can boot just fine as long as neither of the IDE cables are plugged in. I am going to start searching for anything I plugged in incorrectly. |
| LPZ:
If you running windows 2000 make sure you load your configuration file thru the serial port. |
| CPickler:
I'm running XP. I haven't actually been able to load up a configuration yet. I went through and checked all the connections. All of them were on NO a couple of them the female quick disconnect was not seated properly and that has been fixed. But I still get the problem with any of the IDE cables attached. Do I need to just boot up with just the card abd keyboard and serial cable connected to load a configuration before connecting the IDE cables? |
| CPickler:
if some of the buttons are not grounded properly could that cause the problem? I have all of them connected to ground, but I think that a few of the connections may be loose or something. Actually there is a possibility that any of the connections could of course be bad, I haven't gotten to test any of it yet. |
| LPZ:
Just a thought here: check the keyboard passthru port to make sure you have your input and output correct. If their wrong, nothing will work. |
| Navigation |
| Message Index |
| Next page |
| Previous page |