Main > Main Forum
Hagstrom KE72 Error
<< < (5/6) > >>
CPickler:
Well I called tech support and I feel like a complete moron.

I had the control panel flipped over and I was using a pillow to prevent the chair from scraping up the board.  Well the pillow was pressing buttons.  And of course you can't start a computer with buttons pushed on the keyboard..... yeah


So I flipped it over and it worked just fine. 
SteveJ34:

--- Quote from: CPickler on April 25, 2005, 04:23:18 pm ---Well I called tech support and I feel like a complete moron.

I had the control panel flipped over and I was using a pillow to prevent the chair from scraping up the board.  Well the pillow was pressing buttons.  And of course you can't start a computer with buttons pushed on the keyboard..... yeah


So I flipped it over and it worked just fine. 

--- End quote ---

Heh....we've all been there at one point or another.

After seeing the pics of your wiring I figured it was something simple which is why I asked if you had the CP right side up when you were testing.

Best of luck as you proceed....bark if you hit another "pillow" block.

Steve


CPickler:
Yeah, I somehow missed that comment.  I read the last comment and was like I don't remember him asking that, then I scrolled up and saw I missed an entire comment.  Oops
SteveJ34:

--- Quote from: CPickler on April 25, 2005, 06:14:30 pm ---Yeah, I somehow missed that comment.  I read the last comment and was like I don't remember him asking that, then I scrolled up and saw I missed an entire comment.  Oops

--- End quote ---

We forgive you....or at least *I* do. :)

Your panel setup is close to my original upright where I used a Hagstrom encoder with  breaout boards. Once wired and installed, you'll be pleased to know it has worked flawlessly from day one.

Happy gaming!


CPickler:
that is very good to know.
Navigation
Message Index
Next page
Previous page

Go to full version