| Main > Main Forum |
| Rotary adapter for Happ/Midway 49-way Joystick |
| << < (7/25) > >> |
| specfire:
I'm glad I'm wrong and sorry about assuming that the detection scheme was the same as the P360. So, put me down for one of the kits. I would definitely prefer the basic kit vice a completed package. I can do my own soldering etc. Just to check though that you would sell the sleeve, armature, and 12-position switch together or would you just sell the sleeve and I would have to order the parts from Happ? Either way is OK. Specfire |
| fl0yd:
--- Quote from: specfire on April 20, 2005, 04:33:15 pm ---Just to check though that you would sell the sleeve, armature, and 12-position switch together or would you just sell the sleeve and I would have to order the parts from Happ? --- End quote --- |
| IntruderAlert:
--- Quote from: mahuti on April 20, 2005, 11:57:53 am ---The problem with using a trigger stick in this application, is that you can't use the 2 available trigger stick types with the rotary in its current form. Type 1; Has dangling wires... needs to be restricted. Can't work with a rotary, unless you want a restricted movement on your rotary (bad) or you would need some elaborate sliding wiring harness Type 2; Has a plunger that hits a plate. The rotary covers the end of the stick where the plunger would exit. Also, the combination of the rotary & the plate would make for a very deep stick. --- End quote --- I suppose you could use a swivel connector on the wires but the trigger type control is out because the trigger would rotate into the wrong position when you turn it |
| 2600:
--- Quote from: fl0yd on April 20, 2005, 04:56:06 pm --- Based on the responses, I have a meeting with the plastics company to make a protoype for the the stabilizers. Currently the one in the picure is from my Happ Rotary. I'm not aware of Happ selling them without the whole rotary joystick. I hope to have some cost estimates and delivery estimates by next week. --- End quote --- Happ part numbers for the sleeve(96-1012-00) and the set screws (95-8031-00). |
| fl0yd:
--- Quote ---Happ part numbers for --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |