Main > Main Forum

Rotary adapter for Happ/Midway 49-way Joystick

Pages: << < (22/25) > >>

Druin:

I can't remember how I came up with my numbering system for the pinouts on the harness, but I wasn't following any conventions. I was using the JST connector (original) but I don't know where pin 1 really is, I just took a picture of the connector and said "THis is what I'm calling pin 1" so I may be backwards.  I was trying to illustrate the mapping from end to end since it's not a 1 to 1 cable and some people wanted to know how to map it. 
I should go through the site info and update/correct things whenever I get a chance. I have a lot of fixing up I could do.

fl0yd:


--- Quote ---I should go through the site info and update/correct things whenever I get a chance
--- End quote ---

Have you gotten around to this?

Druin:

I think my chart was right because I found that every pin from 1 through 13 were numbered on my jst connector so that's what I followed when I made my table of pin map info and showed the picture showing where I'm calling pin 1 on the JST.


jlml:

The "everything panel" that everyone dismisses takes one step closer to reality...


--- Quote from: Lilwolf on April 20, 2005, 08:05:41 am ---Ok... just to make the ultra in way cool.

How about adding a button to the joystick?

Your already replacing the bottom 1/2 of the shaft.
--- End quote ---


fl0yd:

I agree that it would be cool to have a joystick that did it all.

Pages: << < (22/25) > >>

Go to full version