| Main > Main Forum |
| Rotary adapter for Happ/Midway 49-way Joystick |
| << < (22/25) > >> |
| Druin:
I can't remember how I came up with my numbering system for the pinouts on the harness, but I wasn't following any conventions. I was using the JST connector (original) but I don't know where pin 1 really is, I just took a picture of the connector and said "THis is what I'm calling pin 1" so I may be backwards. I was trying to illustrate the mapping from end to end since it's not a 1 to 1 cable and some people wanted to know how to map it. I should go through the site info and update/correct things whenever I get a chance. I have a lot of fixing up I could do. |
| fl0yd:
--- Quote ---I should go through the site info and update/correct things whenever I get a chance --- End quote --- Have you gotten around to this? |
| Druin:
I think my chart was right because I found that every pin from 1 through 13 were numbered on my jst connector so that's what I followed when I made my table of pin map info and showed the picture showing where I'm calling pin 1 on the JST. |
| jlml:
The "everything panel" that everyone dismisses takes one step closer to reality... --- Quote from: Lilwolf on April 20, 2005, 08:05:41 am ---Ok... just to make the ultra in way cool. How about adding a button to the joystick? Your already replacing the bottom 1/2 of the shaft. --- End quote --- |
| fl0yd:
I agree that it would be cool to have a joystick that did it all. |
| Navigation |
| Message Index |
| Next page |
| Previous page |