Thanks, the sides of the cab took forever to finalize. I was trying to get it to the point of looking cool but not overly complicated.
The cab is around 20" tall, 15" wide and 26" deep. It was built around an old PC monitor.
The plexi I have done so far has been horrible. The bends have been bubbled and the cuts cracked. I will work on it more once I have created a bend jig and put a new blade in the jigsaw. It is about a 1.5" bend at the front edge and then extends down to the bottom. It should look cool if I get it to work right.
The sides will probably be painted or covered in contact paper (wanted to use laminate, but have yet to find it anywhere). It is just going to be a solid color. I chose the color a long time ago, but forgot what my final decision was
.
My router bit is on the way, so I should be able to get the t-molding going here pretty soon.
I will probably get a section for the cab on my website after the midterms.