Main > Software Forum
GunCon2 driver here!!! (Bacon is tasty)
zaktallica:
If someone can please give me a step by step guide 2 get these damn 2 guncons working in mame and having both guns track there own reticule and either use off screen reload or map a button for it i would GREATLY appreciate it..Also some games have buttons that shoot grenades etc so if I can map buttons for this that would be great. Both guns work fine in windows..
hawkeye06:
Hi I am trying to build the circuit below pictured earlier in this thread. I have it mostly build on breadboard, where do you get the +5v from? Can you use one cable coming from a computer?
--- Quote from: IntruderAlert on May 01, 2005, 01:01:44 am ---
--- Quote ---Here are more detailed information on the interface you NEED to build to make the gun work.
First of all, you should not need any hardware mod if you are planning to use the gun with a composite TV-OUT and a normal CRT television set. This circuit is only for people wanting to use the VGA RGB+SYNC connection on an arcade monitor. I didn't test the TV-OUT solution, but I am confident it will work. I am quite sure, however, that you CANNOT take the sync from the VGA for the arcade mon and connect the guncon2 to the TV-OUT. I tried it and it DID NOT WORK.
There are a lot of way to reach our goal of obtaining a good composite-sync but I've tried this and it works. I think the original schematics come from a project of Tomi Engdahl born to connect VGA to normal television but I am not sure of this since you can find it on many sites.
The HSYNC and VSYNC signals can be found on pins 13 and 14 on the VGA. The CSYNC out must be connected to yellow connector on the GUN
Add to the component list in the image two 2.2uF / 16v capacitors (C1 e C2).
I've found and modified a pcb on the net for the above circuit, sorry for the author but I can't find the link anymore.However many thanks.
Postato da: SmogDragon a 10:48 | link | commenti
--- End quote ---
http://lightgun.splinder.com/
--- End quote ---
Monkee:
Am I too late? I'm considering to buy two GunCon2 but I cannot find the Wingun drivers anymore...
yotsuya:
PM me your email address. I might have them at home.
Billkwando:
--- Quote from: Monkee on February 05, 2014, 12:15:40 pm ---Am I too late? I'm considering to buy two GunCon2 but I cannot find the Wingun drivers anymore...
--- End quote ---
Only 4 years late? :p
I don't know when this version is from, but the date on the file is 2010. I hope it helps. I can look around for another version on my old HDDs if there's a specific reason you need it.
Edit: Lemme know if it's any good and what you're using it for. I haven't messed with guncons in a while.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version