Main > Main Forum

LS-30's

Pages: << < (4/5) > >>

samusaran:

try and take some later.its not a pretty sight but hey it works.i took 1 end of hdd cable and split it to leave the 13 wires needed.i tried it on joystick side but it was a bit tight so i used this plastic plug i found which fitted perfect.then joined them in middle.

samusaran:

here we go







Hoagie_one:

quite a hack job, good going

samusaran:

now i know it works i'll tidy it up a bit.

Druin:

WHAT DID YOU DO TO MY INTERFACE??
Hahahah nice cable.  I've been wondering if I can find a compatible connector (the proper pin size) that would make an easy to build harness.  Then I could at least provide part numbers and possible sources for anyone needing them for times like this.
The original connector I think was JST and I looked through the catalogs once and didn't see anything (didn't look too hard).  But I think Amp might make something that fits.
I'm doing something at work that involves a 3 pin connector that looks mighty similar to these pins so when I get samples in I'm going to see how they mate to the LS30 pins.

Pages: << < (4/5) > >>

Go to full version