Main > Main Forum
LS-30's
<< < (4/5) > >>
samusaran:
try and take some later.its not a pretty sight but hey it works.i took 1 end of hdd cable and split it to leave the 13 wires needed.i tried it on joystick side but it was a bit tight so i used this plastic plug i found which fitted perfect.then joined them in middle.
samusaran:
here we go





Hoagie_one:
quite a hack job, good going
samusaran:
now i know it works i'll tidy it up a bit.
Druin:
WHAT DID YOU DO TO MY INTERFACE??
Hahahah nice cable.  I've been wondering if I can find a compatible connector (the proper pin size) that would make an easy to build harness.  Then I could at least provide part numbers and possible sources for anyone needing them for times like this.
The original connector I think was JST and I looked through the catalogs once and didn't see anything (didn't look too hard).  But I think Amp might make something that fits.
I'm doing something at work that involves a 3 pin connector that looks mighty similar to these pins so when I get samples in I'm going to see how they mate to the LS30 pins.
Navigation
Message Index
Next page
Previous page

Go to full version