Main > Project Announcements

Arcade Bones (Marquee & Dashboard graphics finalised)

Pages: << < (88/135) > >>

Bones:

Should have also mentioned.....

If after reading the instructions and looking over the parts another 10 times and I still feel I am completely out of my league, where I work there are about 12 electricians and 2 electrical engineers so I might send out an email advertising a free case of beer for assembly and see what happens.

However, much of me yearns to take up the challenge myself so the decision to have somebody else assemble it doesn't sit well at the moment.

Time will tell.

Sinner:


--- Quote from: BrokenBones on September 15, 2005, 03:18:46 am ---Should have also mentioned.....

If after reading the instructions and looking over the parts another 10 times and I still feel I am completely out of my league, where I work there are about 12 electricians and 2 electrical engineers so I might send out an email advertising a free case of beer for assembly and see what happens.

However, much of me yearns to take up the challenge myself so the decision to have somebody else assemble it doesn't sit well at the moment.

Time will tell.

--- End quote ---
Maybe you could get one of them to look at the kit and give some advise, before you start...I don't envy you that's for sure...good luck...

Stingray:

Just because you're dangerously underqualified is no reason to not do it. Look at me, I do crazy stuff all the time and only land myself in the emergency room every once in a while. ;)

Disclaimer statement: Hey kids, just because Stingray is a moron doesn't mean you have to be one too.

-S

patrickl:


--- Quote from: Stingray on September 15, 2005, 12:39:50 pm ---Disclaimer statement: Hey kids, just because Stingray is a moron doesn't mean you have to be one too.

--- End quote ---
You stop being a "moron" by learning. So I 'd say it's a good idea to try things out. Of course there are limits ... ;)

I have put several of these kit things together and I know little about electronics. You just solder in the components.  How hard can it be? It can't be more difficult than a jigsaw puzzle. Allthough I must admit this puzzle looks a bit more daunting than the ones I tried.



Bones:

Saturday update.

Update about 5 hours earlier than normal today. I have a visitor coming over soon and a plan has been put in place to drink beer, lots of beer.

For a few hours today I did more sanding and then re-puttied some of the areas I wasn

Pages: << < (88/135) > >>

Go to full version