Main > Project Announcements
Arcade Bones (Marquee & Dashboard graphics finalised)
Bones:
Next was the marquee light.
I went to a hardware store and went looking for something that was
Bones:
Where the control panel box will mount to the cabinet I glued and screwed a big piece of pine. I also did the same inside the cabinet. I didn
Bones:
Things I still need to do before preparing to paint.
Order some more wood for the back panels and attach with T-nuts. (8mm MDF)
Install volume control (pot) on dashboard.
Fix some rough areas. (Coin door hole and some damage on the bottom from moving it. Other little stuff.)
Make speaker grill for speakers under marquee
Final pics of today
Bones:
I was wondering if the marquee light would be bright enough but this pic confirmed all should be OK.....
*Edit- Bacon is Tasty.
RaggedEdge:
I like the way you are bolting down the control panel to the base of the cabinet. I rigged up some latching clamps but I know if I were to try to sit on the front of the control panel, it would all come tumbling down. Your cabinet is looking great!
Hmmmm...."Bacon is tasty".....I think I am finally starting to figure out this Bacon fascination.