| Main > Main Forum |
| Special GP-Wiz49 version for DRS Mode selection via a rotary switch , etc... |
| << < (3/4) > >> |
| Flinkly:
his version is the happs version, the midway is almost the same, but the shaft is a little smaller at the bottom...or bigger, i forget which. |
| RandyT:
--- Quote from: Flinkly on April 06, 2005, 03:13:17 pm ---his version is the happs version, the midway is almost the same, but the shaft is a little smaller at the bottom...or bigger, i forget which. --- End quote --- Smaller. RandyT |
| Tiger-Heli:
Randy, Did my question above get lost in the noise other thread traffic? |
| RandyT:
--- Quote from: Tiger-Heli on April 06, 2005, 03:36:06 pm ---Randy, Did my question above get lost in the noise other thread traffic? --- End quote --- As this firmware won't be released until the support for software switching is in place (recent decision) there isn't a real answer for the question yet. Originally, I decided that shifting the buttons around would be too confusing for people to keep straight. But it's open for debate at the moment. RandyT |
| NoOne=NBA=:
Would it be feasible to reprogram the chip to use the highest 8 buttons for modeswitching? That would eliminate the button numbering confusion between "normal" and "constant programming" modes, for the lower numbered buttons. |
| Navigation |
| Message Index |
| Next page |
| Previous page |