Main > Main Forum
Oldie But Goodie
<< < (4/4)
Tiger-Heli:
Actually, the proper way to use T-nuts (and the most professional way to do this also), is what OSCAR did on the Williams Multicade at http://www.oscarcontrols.com/sinistar/index.shtml  Note that the T-nuts go on the top, screws go from the bottom, dust washer is routed out, and overlay and plexi go above everything. (might have used two sheets of plexi?)

--- Quote from: Grauwulf on April 05, 2005, 11:21:24 pm ---how do you countersink bolts, or screws for that matter?

--- End quote ---
Actually, (for wood screws, not machine screws) they make countersink bits that you are supposed to use that match the chamfer of the screw head.
Navigation
Message Index
Previous page

Go to full version