| Main > Main Forum |
| Mounting my I-Pac |
| << < (3/4) > >> |
| Sinner:
I wanted spacers to hold my mobo off the inside of my cab, so I went to Home Depot and picked up some nylon nuts (they're an easy way to make sure the spacing is the same and for $0.29 each I don't have to bother cutting anything to size)... Basically, anything that doesn't conduct electricity very well should work (IE: rubber tubing, plastic tubing, etc)... Mark the holes, predrill and run the screws through your board and the spacer of your choice... |
| Paul Olson:
I used the motherboard standoffs, too, and they have worked great. How is everyone mounting the AKI Boards? No mounting holes on these. Paul |
| koolmoecraig:
Velcro dude. Velcro. Leaves no marks, it's pretty much impossible to screw up, and you can remove it instantly. What's the point of nylon nuts, washers, marking holes, drilling holes etc? Oh yeah, it costs about 50 cents. |
| cholin:
Doesnt velcro cause static electricity? Either way, Im cheap so Im gonna use a cheap pen. You throw them out every day because they dont work....why not put it to good use! |
| Hoagie_one:
I've used teh bic pen in the past....getting good cuts is another issue though |
| Navigation |
| Message Index |
| Next page |
| Previous page |