| Main > Main Forum |
| mounting 4 way pacman/galaga reunion...allternate ways??? |
| << < (3/5) > >> |
| hulkster:
so im guessing the omni-stick is the best choice here. my question is, can this be mounted underneath 3/4" mdf without any recessed section or mounting plate? |
| Tiger-Heli:
--- Quote from: hulkster on April 05, 2005, 08:56:58 am ---so im guessing the omni-stick is the best choice here. my question is, can this be mounted underneath 3/4" mdf without any recessed section or mounting plate? --- End quote --- Whoa, Doggie - I thought you already had a reunion stick. If so, you could mount it below panel with one of RandyT's Versa-ball joystick shafts. If not, the Omni-Stick with the mounting plate is a good choice (roughly $25), but you do have about 1/10" 5x5 plate above the CP. Otherwise the E-Stick or T-Stick from www.ultimarc.com is an option, although I don't like the fascia on the E-Stick, and (from what I've read) not sure about the stiff springs/short travel of the T-stick. |
| hulkster:
okay, i DO have a reunion joystick, but i dont have a router to recess a section in the cp. so what im wanting is a dedicated 4 way joystick that can be mounted similar to the super 8's from happ. all i want to do is drill a hole in the cp and mount a 4 way joystick underneath just as i would a super 8. understand? if you know of a way to do this with my existing reunion joystick, i would be happy to hear it. |
| Tiger-Heli:
--- Quote from: hulkster on April 05, 2005, 09:09:04 am ---okay, i DO have a reunion joystick, but i dont have a router to recess a section in the cp. so what im wanting is a dedicated 4 way joystick that can be mounted similar to the super 8's from happ. all i want to do is drill a hole in the cp and mount a 4 way joystick underneath just as i would a super 8. understand? if you know of a way to do this with my existing reunion joystick, i would be happy to hear it. --- End quote --- Okay, back to square one - Go to the link I posted above for the Versaball joystick shafts (they start at $11.99). Pick out the appropriate color, texture, size, etc. (your choice). Pick up a dust washer ($1.99) if you need one (don't have one lying around). Remove reunion joystick shaft, mount reunion joystick to bottom of panel, install Versa-ball shaft at desired height. You might want to try this in scrap 1x4 first. You might want to verify with RandyT that the Versaball shaft works with the reunion stick. |
| hulkster:
okay i will check with RandyT....im guessing he is the owner of the website you gave me a link to? also, i have never seen a dust washer i dont think....is that the black plastic ring that fits around the joystick between your hand and the cp? |
| Navigation |
| Message Index |
| Next page |
| Previous page |