Main > Main Forum
What to do with this thing?
<< < (7/7)
menace:
Suitcase-cade--LMAO--not only because thats hilarious that its actually been done but more so that I had already considered but rejected it cause that is just too far out there--even for me :D

As far as redrafting the plans--it won't take me very long since I'm much more comfortable with CAD than illustrator--was just trying to save a step--no biggie.

(still marvelling the suitcase-cade--ingenious!)
Lilwolf:
I vote for a bar-cade.  Not a bar top... but build a cocktail table in the end of a bar....

Make it at the end so you can play vertical games that way... and horizontals on the side. 

I think that would be REALLY cool!
menace:
redrafted the plans at 1/3 scale (1/4 was too small) and it looks like i might be able to do it if I can place all the power supplies outside the box--maybe one of those mini-atx power supplies--hmmm... but the iso-transformer definitely has to go outside the case unless i extend the bottom by 6 or 7 inches.  I want to make it look somewhat to scale and not cheat too much..
Flinkly:
as for controls, just pick up some nintendo buttons.
menace:
LOL--well i admire your enthusiasm but until I start cutting, its all just mental gyrations at this point  ;)  I could use some creative ideas for the monitor and PC power supplies still..

I think the pc is going to be a celeron 433 mini-atx board running arcadeos and advmame.  I'll have to scroungs for a laptop drive, otherwise it will be a desktop drive installed somewhere inside...
Navigation
Message Index
Previous page

Go to full version