Main > Main Forum
Mini-PAC
<< < (5/5)
romperwomb:

--- Quote ---
Ok. I now have a couple of Mini-PAC PCBs.

I've noticed how thin the wires are in an IDE cable. Is it plausible to find some sort of extention header(a stand-alone IDE connector) where 20 gauge wires could be attached to each pin?

Thanks.


--- End quote ---

Pick up some Terminal Strips from Radio Shack.

The IDE wires come in on one side and 20 gauge out the other.
Tiger-Heli:

--- Quote from: romperwomb on July 25, 2006, 11:05:20 am ---Pick up some Terminal Strips from Radio Shack.

The IDE wires come in on one side and 20 gauge out the other.

--- End quote ---
See Reply #10 above.  ;D
Searcher7:

--- Quote from: Tiger-Heli on July 25, 2006, 05:14:09 pm ---
--- Quote from: romperwomb on July 25, 2006, 11:05:20 am ---Pick up some Terminal Strips from Radio Shack.

The IDE wires come in on one side and 20 gauge out the other.

--- End quote ---
See Reply #10 above.  ;D

--- End quote ---

I'm trying to find a solution around the small wire gauge problem.(I'm used to using 20g minimum on all my projects).

Darren
Navigation
Message Index
Previous page

Go to full version