Main > Main Forum
Its been a while since i've been here. New project idea.
<< < (2/5) > >>
Grasshopper:
I'm not sure what you mean by a PCB hack. The sockets in the switchbox came pre-wired so that saved me a lot of soldering. As I used a standard Ipac (not a Minipac) I just had to strip the ends of the wires and connect them to the Ipac's screw connectors.

I'll post pictures when I get a chance.
PixelCloud:

--- Quote from: Grasshopper on March 27, 2005, 02:40:28 pm ---I'm not sure what you mean by a PCB hack. The sockets in the switchbox came pre-wired so that saved me a lot of soldering. As I used a standard Ipac (not a Minipac) I just had to strip the ends of the wires and connect them to the Ipac's screw connectors.

I'll post pictures when I get a chance.

--- End quote ---

i should probably explain myself more... lol

what i mean is you could of put all the wires going to a pcb in the controllers and have traces going to the 36 pin connector
PixelCloud:
ok


question time...

there are 13 wires going from each controller to the ipac, im' looking for some cable, perferrablly a round connector, that is flexible and has space for atleast 13 wires..
oldsage:

--- Quote from: PixelCloud on March 27, 2005, 05:34:38 pm ---ok


question time...

there are 13 wires going from each controller to the ipac, im' looking for some cable, perferrablly a round connector, that is flexible and has space for atleast 13 wires..

--- End quote ---

Round??? I'm not sure i know what you mean by "round", but DB15 has 15 pins, and can be had from RadioShack for about 1.50-2$ each... Hope that's round enough for ya
Flinkly:
what about a cat5 cable?
Navigation
Message Index
Next page
Previous page

Go to full version